Quality 1st Basement Systems Before & After Photos

To eliminate musty odors and cold floors, this homeowner contacted Quality 1st Basements  to encapsulate their crawl space. Our Senior Design Specialist, Jeff N., headed out to inspect the site and our team led by Wilver completed the installation. 

We installed SmartJack Stabilizers to provide additional support to the floor joist and crawl space beams to prevent sagging floors and structural issues in the future. Our team also installed our CleanSpace Vapor Barrier System to prevent moisture and water from seeping through the foundation wall.  

When they noticed their basement wall was cracked and bowing, this homeowner contacted Quality 1st Basements for a solution. Our senior Design Specialist, Ken P., provided the homeowner with a designed solution that best fit the needs of this homes foundation. This  included the installation of the CarbonArmor System. Wilver, our project Foreman, and his team headed out to the site and installed Our Reinforcement Wall System.

The walls are now completely stabilized and the homeowner no longer has to worry about their basement wall caving in. This system provides the ultimate solution since it will now prevent future movement, it can be adjusted to gradually pull the wall back towards its originally position and finally it can be covered if the homeowner decides to finish their basement. 

Our Concrete Repair team lead by Ash, raised this sinking apron back to its original state. The team was able to seal the crack with JointSeal to prevent a new crack from forming. 

Bob, a homeowner living in the Bridgewater area of New Jersey, contacted Quality 1st Basements hoping for a solution to his settling sidewalk in front of his home. Our Customer Care Representative, was able to schedule him an appointment with Jay Hugee, our System Design Specialist. 

Upon arrival Jay noticed the big eye sore in front of Bob's beautiful landscaped home, his sidewalks. Jay and Bob walked over each sinking slab, Jay measuring each one and then sat down to go over why his slabs were sinking and the goal he had for his sidewalks. 

Bob stressed that replacing the sinking concrete was not an option for the time and disruption was going to cause him stress. Jay recommended our PolyLevel solution. Check out the great work our PolyLevel Foreman, Ash and his team did to raise the slabs back to level, removing the trip hazards and the eye sore in front of Bob's home. 

This sidewalk in Bridgewater, NJ had three slabs that were sinking and settling about 3 inches into the ground. Quality 1st Basement injected PolyLevel underneath the slab and lifted it back into place. PolyLevel sets in just 15 minutes and is a cheaper option than replacing concrete.