Concrete Lifting and Leveling Before & After Photos

Check out this amazing before and after of the front step area we lifted back towards its original position in Moorestown, NJ. Our crew drilled small penny-size holes into the concrete area to inject polyurethane foam underneath. PolyLevel is a light weight, waterproof and environmentally friendly foam that expands when injected to fill all voids underneath the slab. Once the slab is leveled, it begins to harden to permanently stabilize the concrete slab. 

A homeowner in Moorestown, NJ was looking for a permanent solution that would lift the front of the garage slab back into its original position. The homeowner was pleased to see the difference our polylevel technology did to the concrete slabs. The tripping hazards were removed once and for all.

A Moorestown, NJ homeowner discovered their concrete driveway was settling a few inches. They contacted Quality 1st Basement Systems for an estimate. System Design Specialist, Jeff P., provided a thorough inspection of the concrete and recommended the Polylevel Injection as the best solution. Polylevel is a waterproof concrete repair solution. It consists of a foam injected underneath the slab and lifted as close to its original height as possible. When rain pours, the foam does not disintegrate, preventing the concrete from sinking again! Since the installation, the homeowner has not experienced any other concrete issues around their home.

This Monroe Township driveway had settlement issues where the driveway and the garage met. The homeowner didn't like the way it looked nor the bump his car had to drive over each day he drove in and out of his garage. He called Quality 1st for a free estimate! A Design Specialist recommended the PolyLevel System which would easily permanently lift the driveway back to its desired level, removing the small bump. The homeowner was very pleased to see how quick and easy it was, plus how well the crew cleaned up!   

The homeowner in Williamstown, NJ noticed their one driveway slab had settled a little in their driveway. At first they thought nothing of it but over time their foot would start to catch it on the way to the car. Realizing that one of them could get hurt they contacted Quality 1st to take a look to see what could be done. System Design Specialist Maurice Robinson recommended PolyLevel. A small whole was drilled into the slab which pumped a small amount of PolyLevel foam solution underneath. The foam then expands and hardens raising the slab back to its original level.