Foundation Repair Before & After Photos

A homeowner in Hillsborough Township, New Jersey had stair step cracks along the outside of their brick home. The homeowner contacted Quality 1st for a solution. Our specialist inspected the home and noticed the stair step cracks.

 Push Piers  were installed outside the home to provide the foundation with support. Push Piers are the best opportunity to lift the home to its original position and they are fast and effective. 

This homeowner in Hillsborough, New Jersey contacted Quality 1st Basement Systems to stabilize their foundation wall. Our System Design Specialist, Laura M, suggested a wall reinforcing system. Our foreman Jonathan and his crew installed our Carbon Armor Wall Reinforcement System. CarbonArmor is a long-lasting and durable system that's ten times stronger than steel. It's intended to stabilize the foundation walls and is applied to the wall with epoxy resin. 

This homeowner in the Hillsborough, NJ hired Quality 1st Basement Systems to waterproof their partially finished basement and address the concerns they had with their block foundation. The block foundation walls had horizontal cracks and began bowing inward. We installed our CarbonArmor Reinforcement System which stabilizes the basement wall and prevents future movement. This system will not effect the homeowners process for finishing their basement. 

An existing customer of ours had referred us to Deborah from Stanhope, NJ who noticed large stair step cracking in the exterior of her foundation. We sent Senior Design Specialist, Jeff Nero out to inspect the foundation and design a solution that would stabilized the foundation permanently.

Jeff recommended our State of the Art Push Piers. The perfect solution for any home that has shifted or settled. Jeff explained that cracks form when the soil beneath your home is no longer strong enough to support the foundation, and therefore when the foundation shifts, cracks form from the movement. Ignoring cracks in a foundation will only increase the chances of the foundation becoming unstable and unsafe. Jeff designed a solution where  16 Push Piers would be installed on the outside of the foundation, deep in the strong soil to transfer the weight of the home to the piers to prevent further settling and movement. 

Princeton homeowner faced bowing walls in his basement. A System Design Specialist determined that the leaning walls were caused by pressure from the outside earth. The soil around the home was putting a lot of pressure on the foundation walls. Quality 1st installed the CarbonArmor foundation repair system which adheres to the wall to support the foundation.